Understanding the Effects of Sample Preparation on the Chemical Structures of Petroleum Imaged with Non-contact Atomic Force Microscopy

This study addresses the effect of sample preparation conditions on the structural integrity and composition of heavy hydrocarbon mixtures imaged by non-contact atomic force microscopy (nc-AFM). We designed and prepared a set of organic molecules mimicking well- accepted key characteristics of heavy oil asphaltenes including molecular architecture, molecular weight, boiling point, atomic H/C ratio and bond strength. We deliberately focused on multi-core molecule structures with long aliphatic linkers as this architecture was largely absent in previous nc-AFM studies of petroleum samples. The results confirm that all these molecules can be successfully imaged and remain intact under the same preparation conditions. Moreover, comparison with ultra-high resolution FT ICR-MS of a steam-cracked tar asphaltene sample suggests that the single molecules identified by nc-AFM span the entire molecule spectrum of the bulk sample. Overall, these results suggest that petroleum molecules within the scope of chosen molecules studied herein can be prepared intact and without bias and the imaged data can be representative.

For further information please contact lgr@zurich.ibm.com

By: Yunlong Zhang, Bruno Schuler, Shadi Fatayer, Leo Gross, Michael R. Harper, J. Douglas Kushnerick

Published in: Industrial & Engineering Chemistry Research , volume 57, (no 46), pages 10.1021/acs.iecr.8b03962 in 2018


This Research Report is available. This report has been submitted for publication outside of IBM and will probably be copyrighted if accepted for publication. It has been issued as a Research Report for early dissemination of its contents. In view of the transfer of copyright to the outside publisher, its distribution outside of IBM prior to publication should be limited to peer communications and specific requests. After outside publication, requests should be filled only by reprints or legally obtained copies of the article (e.g., payment of royalties). I have read and understand this notice and am a member of the scientific community outside or inside of IBM seeking a single copy only.


Questions about this service can be mailed to reports@us.ibm.com .