ISO is currently in the first of its three-phase process for developing an international standard for statistical tolerancing of mechanical parts. In this phase the technical scope of the future standard is being defined by a group of international experts. This paper describes the technical deliberations that have been undertaken thus far and the standards development process used for this purpose.
By: Vijay Srinivasan
Published in: RC20698 in 1997
LIMITED DISTRIBUTION NOTICE:
This Research Report is available. This report has been submitted for publication outside of IBM and will probably be copyrighted if accepted for publication. It has been issued as a Research Report for early dissemination of its contents. In view of the transfer of copyright to the outside publisher, its distribution outside of IBM prior to publication should be limited to peer communications and specific requests. After outside publication, requests should be filled only by reprints or legally obtained copies of the article (e.g., payment of royalties). I have read and understand this notice and am a member of the scientific community outside or inside of IBM seeking a single copy only.
Questions about this service can be mailed to reports@us.ibm.com .