Controlling Quality of Service in Multi-Tier Web Applications

The need for service differentiation in Internet services has motivated interest in controlling multi-tier web applications. This paper describes a tier-to-tier (T2T) management architecture that supports decentralized actuator management in multi-tier systems, and a testbed implementation of this architecture using commercial software products. Based on testbed experiments and analytic models, we gain insight into the value of coordinated exploitation of actuators on multiple tiers, especially considerations for control efficiency and control granularity. For control efficiency, we show that more effective utilization of tiers can be achieved by using actuators on the bottleneck tier rather than only using actuators on the entry tier. For granularity of control (the ability to achieve a wide range of service level objectives) we show that a fine granularity of control can be achieved through a coordinated, cross-tier exploitation of coarse grained actuators (e.g., multiprogramming level), an approach that can greatly reduce controller-induced variability.

By: Yixin Diao; Joseph L. Hellerstein; Sujay Parekh; Hidayatullah Shaikh; Maheswaran Surendra

Published in: RC23929 in 2006

LIMITED DISTRIBUTION NOTICE:

This Research Report is available. This report has been submitted for publication outside of IBM and will probably be copyrighted if accepted for publication. It has been issued as a Research Report for early dissemination of its contents. In view of the transfer of copyright to the outside publisher, its distribution outside of IBM prior to publication should be limited to peer communications and specific requests. After outside publication, requests should be filled only by reprints or legally obtained copies of the article (e.g., payment of royalties). I have read and understand this notice and am a member of the scientific community outside or inside of IBM seeking a single copy only.

rc23929.pdf

Questions about this service can be mailed to reports@us.ibm.com .